KAREL2019

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: [SOLVED] SEEBURG SC2 can't selects A1toV1 + LP light #46674
    KAREL2019
    Participant

    I did what Scudie suggested and now the right light stays on. The middle light works like it should and turns on again after a selection. All is working now.

     

    thanks everyone for the suggestions and solutions, much appreciated.

    in reply to: [SOLVED] SEEBURG SC2 can't selects A1toV1 + LP light #46670
    KAREL2019
    Participant

    No all are singles as far as I know. The lightbulb is oke because it works in the other sockets

    in reply to: [SOLVED] SEEBURG SC2 can't selects A1toV1 + LP light #46668
    KAREL2019
    Participant

    I found the problem. The middle leaf switch in front of the album relay was making continuous contact because it was stuck at the bottom. When I seperated the leaf plates it was working!

    Only thing changed is that now the most right light bulb dont light up at all, before it turned of when making a selection and turned on again. Now it’s just off all the time.

     

    in reply to: [SOLVED] SEEBURG SC2 can't selects A1toV1 + LP light #46663
    KAREL2019
    Participant

    Thanks Scudie for taking the time to reply in such an extend way.

    To be clear all tracks from B2 to V8 play correctly.

    Only A1 to V1 don’t play the correct track. Pressing A1 will play A8, B1 will play B8 and so on.

    I will look into the manual and see if I can find and check the things you mentioned. (no so savy with electra)

    • This reply was modified 4 years, 6 months ago by KAREL2019.
Viewing 4 posts - 1 through 4 (of 4 total)